Threaded Mode | Linear Mode

flofrucht · 09/04/2011 12:14 PM

Because some guys asked me about a TUT how to install 6.20 PRO-B5 Permanent, I made one.

Works on PSP 1000, 2000, 3000, 4000 or PSPgo!

But your PSP Unit must be 5g or lower!

I tested it by myself on a PSPgo ;=).

For this, you will need:
- PSP 1000, 2000, 3000, 4000 or PSPgo
-6.20 PRO-B5
-Official PSP Firmware 6.20
-6.35/6.31 to 6.20 Downgrader if you aren't on Firmware 6.20
-PSP Module Checker 3.0 to check your PSP unit

Tutorial

1.Extract the downloaded archive.

[Image: sinttuloqm.png]

2.Copy the 620PRO_Permanent, PROUPDATE and the FastRecovery folder to PSP/GAME.

3.Launch the Update 6.20 PRO-B5.

4.Press X to install the 6.20 PRO-B5 CFW.

5.Your PSP is rebooting...

6.Launch the Update 6.20PRO Permanent..
[Image: xmbn.png]

7.Press X (now there's a warning, ignore it, but you can backup the file if you want for safety reasons)
[Image: installz.png]

and then O to install the 6.20 PRO-B5 CFW Permanent.
[Image: isntall2.png]

The secure way:

Spoiler:

8. Congrats...now you're on 6.20 PRO-B5 Permanent, enjoy it ;).

Uninstallation:

1.Run the 6.20 PRO-B5 Permanent Installer again.

2.Press X to uninstall the Permanent Patch.

[Image: 37888348501691634817378.png]

But the vshorig.prx must exist at ms0:/ or ef0:/ vshorig.prx.

Problem-solving:

There's a Recovery combo to uninstall it:
While starting your PSP hold ◯ + x + START + SELECT to uninstall the patch!

Note: If you want to skip the Sony-Logo at startup, hold R while starting the PSP, now you're in the Recovery Menu.

Go to Configuration and enable Skip Sony Logo ;)

Note2: While starting your PSP and holding SELECT you are on OFW 6.20 again ;):

It took me 1 hour to write and test it, it isn't really difficult to say just thanks :).

[Image: snap022c.png]

-flofrucht

Threaded Mode \| Linear Mode [Tutorial] Installing 6.20 PRO-B-5 Permanent
Author	Message