Threaded Mode | Linear Mode

saruba · 03/04/2010 09:38 PM

Materials:
-Transistor 2N2222A (available on radio shack or electronics store)
-0603 smd led's (ebay),(test them with a multimeter)
-kynar wire 30 gauge (radio shack or electronics store)
-soldering iron 15-20 watts and "skill" (radio shack or electronics store)
-Glue gun or tape (any crafting shop,even walmart)
-Drill (really small)
Smokingg

If you don't have "SOLDERING" exp. do some practice 1srt in any old board,chip or cable.Use soldering "FLUX" always for top results.
If you use red leds 2.6v put a 100ohms resistor between motherboard and 1srt led,if have installed a switch between switch and 1srt led.Do this just in this case.
-I make this tuto from Folklord36 & Lordnico more easy to understand and user friendly hope help you out.
[Image: soundreactiveledstutbys.jpg]

-Use 2 or 4 led's.Add this to others led's.
Clear UMD door cost $3 bucks aprox or the entire housing cost $20-$25 bucks on EBAY.
Picture download:http://www.megaupload.com/?d=GVH4OK0G

Madwin

Heres my PSPslim using this tutorial:

+ UMD door with 2 LEDs Adore

Threaded Mode \| Linear Mode PSP Slim(2000)Reactive LED's Tutorial Simpler & Brighter!
Author	Message