Threaded Mode | Linear Mode

psp2468 · 17/01/2008 10:42 AM

Hey everyone,

I was wondering if anyone would be so kind as to convert a 3.71 custom paf.prx file (that I made) to a 3.80 file? I would of course give credit when I release the theme with it.

Thank you in advance

If no one can do it, can someone at least tell me how to do it?

Vegetano1 · 17/01/2008 01:11 PM

You need Hex workshop and edit the floats in hte new 3.80 paf.prx,..

Not all 3.71 floats/offsets are found yet for 3.80 paf,.

psp2468 · 17/01/2008 01:40 PM

Vegetano1 Wrote:You need Hex workshop and edit the floats in hte new 3.80 paf.prx,..

Not all 3.71 floats/offsets are found yet for 3.80 paf,.

ah ok. Thank you for responding :)

psp2468 · 24/01/2008 12:00 AM

when i tried copy the floats it cause by psp to brick

Vegetano1 · 24/01/2008 12:08 AM

Take a look at this picture: its how you change float points,.

[Image: f_pic3m_406c81e.jpg]

You need a decrypted uncompressed paf prx to be able to edit and copy into flash0 !!!note that a uncompressed paf is larger and if you have a fat psp it might not fit in the flash0,.. you can use these dummy files,..

uncompressed paf: HERE

dummy files to free up space in the flash0(maybe needed and only on FAT PSP):these copy the "dic" folder to flash0 should be enough don't think you need to flash the dummy font file,.

psp2468 · 24/01/2008 05:04 AM

ah ok. Thank you! You have been a big help :)

Do i have to copy the float for every single one?

matchung · 24/01/2008 08:37 AM

move to help section

psp2468 · 24/01/2008 09:09 AM

please anybody?

Threaded Mode \| Linear Mode Converting an paf.prx file
Author	Message