Endless Paradigm

Full Version: problem with writing to flash0...
You're currently viewing a stripped down version of our content. View the full version with proper formatting.
Pages: 1 2
can any1 help me? my PSP works fine im on version 3.03 c but i can't go to the flash 0 it says usb enabled then it shuts off. any ideas?
Re-install the firmware, that should fix up the problem :)
You need to turn it on in recovery mode, not the XMB.
i open it in the recovery menu but it just shuts down and i can't change the firmware cause i changed all te xmb and it only works with version 3.03 c
double you tee eff are you going on about you can't change the fw read this
http://www.psp-hacks.com/forums/viewtopic.php?id=32989 use the recovery link to get the file to downgrade your psp back to 1.5 then just upgrade again and use the recovery menu to enter flash 0
It has begun....
BlackNinja Wrote:It has begun....
??????
dasme Wrote:
BlackNinja Wrote:It has begun....
??????

The n00bs.
i try to do the eboot in recovery but it shuts down too.
BlackNinja Wrote:It has begun....just tryin to get my posts up
beaner2k6 Wrote:double you tee eff are you going on about you can't change the fw read this
http://www.psp-hacks.com/forums/viewtopic.php?id=32989 use the recovery link to get the file to downgrade your psp back to 1.5 then just upgrade again and use the recovery menu to enter flash 0
all i can't do is open anything in the recovery mode and if i change my firmware i will get bricked cause i changed my xmb and it oly works in version 3.03C and i need to change it so i can upgrade to version 3.30 OE A
akskater009 Wrote:all i can't do is open anything in the recovery mode and if i change my firmware i will get bricked cause i changed my xmb and it oly works in version 3.03C and i need to change it so i can upgrade to version 3.30 OE A

if u change ur firmware any changes in ur flash0 will be reseted to the original
Pages: 1 2
Reference URL's