Slushba132 Wrote:I would go with azumi except for 3 and 4.

Beating the Hell out of it won't fix it and I've modded an xbox, there are no fuses.
I would open it up take some pictures and post it (So I can see what's going on).
Oh and before you ask you will need torx bit screwdriver.

You could also wait...I've had it happen where one day something seems broken and the next it appears to have fixed itself. Also if water was spilled on it, in some unkown way, it would give the water time to dry and it would work after that.

actually all electronics these days have either surface mounted fuses or integrated ones, however they are not usually repairable because of the size issues. in some rare cases you can bypass the fuses but this is very risky - fuses usually blow for a reason, its safer to have a fuse blow than a whole chip, circuit board, console, table, house. (you get the idea :P)

as for the water comment - that will only be true if the console was not used while wet, because if it was it probably won't be easily fixable by drying it out.

only way to be sure is do the obvious - if its a 360 check the psu light and the ring of light as well - they warn of failures. check plug fuses (power surges can and have blown fuses). check power cables. check all cables actually. check internal parts if applicable - loose cables inside can cause errors like this. etc. good luck.